Introduction To Precautions During The Operation Of The Automatic Mold Changing System

2025-03-17

​Compared with the traditional operation mode, the use of the automatic mold changing system can effectively improve work efficiency, and can also avoid some safety hazards that may arise from manual operation. It is more worthy of our choice and trust. However, when choosing to use the automatic mold changing system, there are still some key points about the operation of the equipment that need special attention.


1. Make preparations before turning on the equipment.

Because we choose to use an automatic mold changing system, the operating system will be different, and the type of use of the equipment will also be different. However, the most basic and critical thing is to do basic inspections before application to make sure that the equipment has no faults or other problems. Especially for equipment that has been used for a long time, there will inevitably be some minor problems. Timely inspection and treatment can make us more at ease.


2. Pay attention to check after use.

Every time you operate the automatic mold changing system and use the automatic mold changing equipment, you must also do basic inspections. In particular, you need to determine whether the mold can be automatically changed according to the previous settings, and whether the time and operating mode can be guaranteed. Only by ensuring that the equipment can operate correctly can each use be undelayed and work efficiency can be guaranteed.


  • Email
  • QR
X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy